ºÚÁϸ£ÀûÉç

Specification ^*)

Ìý

(details depend on flow curve characteristics)

100 – 50,000 mPa∙s

10 – 5,000 mPa∙s

1 – 500 mPa∙s

Viscometry: ± 2%

1 – 3 min

Flow curve, 1 – 3 points of viscosity vs. shear rate

Continuous readout

Instrument is water cooled

20 – 40 ± 0.3 °C

IP65 certified according to: EN 60529:1991/A2:2013

<41 dB(A)

H x W x D = 300 x 300 x 220 mm

H x W x D = 415 x 330 x 280 mm (including glands, external heat sink & vibration dampening base)

Up to 15 kg

Stainless steel
Heat sink: Aluminum

Stainless steel 316, Polytetrafluoroethylene (PTFE), Nylon 12, Borosilicate glass & PEEK
Static seals: FKM
Dynamic seals: FKM (optional FFKM)
Waste tube: PE

POM-C

15 – 20 ml after each complete cleaning of instrument

≤ 5 ml

2 – 5 l/h (cooling water may be recycled)

≤ 500 ml per cleaning cycle

200 µm
Low concentration of particles up to 1000µm is tolerated

RheoStream^® FC is CE compliant according to

– EU machinery directive (MD – 2006/42/EC)

– EMC directive (2014/30/EU)

– RoHS directive (2011/65/EU)

Sample inlet maximum tube length 140 mm.
Sample inlet to RheoStream must be placed ± 30 mm horizontally and vertically from process connection.
A free space of 1 m must be clear in front of the instrument to allow for on-site service.

A suitable rack is made by the customer to support RheoStream.
A stainless-steel weld-on plate with M6 thread to fit the vibration dampening base is supplied ºÚÁϸ£ÀûÉç

Vertically mounted process connection valve with copper washer and weld-in fitting connected to ºÚÁϸ£ÀûÉç specification.
0 – 3 barg at process connection (Depending on viscosity).

If cleaning liquid is solvent based or contains additives:
Connect to Solvent IN: 1 – 3 barg push-in fitting Ø4 mm

If cleaning liquid is water (wo. solvents or additives):
Connect to Water IN (same as cooling water). 1-6 barg push-in fitting Ø6 mm

Connect to Water IN: 1 – 6 barg water; push-in fitting Ø6 mm

Waste collection system required for sample/cleaning liquid & cooling water

24V DC 10A

15 – 40°C

15 – 50°C

Ìý 5 – 20°C

Ìý 5 – 20°C

Communication with the instrument through ethernet RJ-45 connection to any system operating an internet browser.

WebGUI on PC/Tablet via ethernet cable.

For automation purposes RheoStream can be interfaced to a Factory Control System either using OPC-UA over Ethernet or via analog/ digital wires using a PLC.

IoT: To provide remote trouble shooting & support, ºÚÁϸ£ÀûÉç requires an internet connection (e.g., a mobile internet connection).

RheoStream instruments are programmed to match individual customer needs. Some of the technical specifications will be adapted.